Wiring and 12v conversion delays
Posted: Sat Jul 16, 2011 3:13 pm
Hey everyone sorry for the delay on the 12v conversion, I've been on vacation, and unfortunately for me, my wiring is not only rat nested but none of them match between handle bars, harness, engine etc. So, I have the wonderful job of tracing each wire out ahead of me. It wouldn't be so bad but apparently, the motor wiring is from a ca77, the handle bar wiring from a ct90, and the harness from who knows...I am also going to be moving out of NC over the next few weeks so there's going to be even more delay to getting around it it ahead. Good luck with all your projects in the mean time! ~Jim