Aluminum polishing intro

Jetblackchemist · Post by **Jetblackchemist** » Sun May 15, 2011 11:25 pm

Done.

wnbasac · Post by **wnbasac** » Mon May 16, 2011 10:33 am

Jim

sounds great look forward to your tutorial
>
tks, lou

Jetblackchemist · Post by **Jetblackchemist** » Tue May 17, 2011 9:32 am

Done.

Jetblackchemist · Post by **Jetblackchemist** » Thu May 19, 2011 1:04 pm

Done.

Smithers · Post by **Smithers** » Thu May 19, 2011 10:52 pm

Whoa that is some fine work. I can't wait for your dyno results!

weestrom05 · Post by **weestrom05** » Fri May 20, 2011 6:22 am

Jet, That is some impressive work. looks great. Cut

Jetblackchemist · Post by **Jetblackchemist** » Sat May 21, 2011 5:26 am

Done.

Jetblackchemist · Post by **Jetblackchemist** » Mon May 23, 2011 5:38 am

Done.

Smithers · Post by **Smithers** » Mon May 23, 2011 7:50 am

You forgot the elbow grease.

wnbasac · Post by **wnbasac** » Mon May 23, 2011 11:45 am

yeeee Haaaa

i think i got it going now thanks gang for the 411
>
man that coating is hard to get off!$%%#%*
>
but i'll keep trying to improve on the technique
>
my 1st attempt
>

Jetblackchemist · Post by **Jetblackchemist** » Mon May 23, 2011 12:02 pm

Done.

wnbasac · Post by **wnbasac** » Mon May 23, 2011 4:04 pm

okie doike i'm off to get me one of those flapper wheels or maybe a couple
>
tks again, lou

Jetblackchemist · Post by **Jetblackchemist** » Mon May 23, 2011 6:30 pm

Done.

65ca95 · Post by **65ca95** » Sat Nov 19, 2011 2:21 pm

Jetblack
Thanks much. New to this and the tutorial is very helpful, especially with all that is needed spelled out. Great stuff.

Jetblackchemist · Post by **Jetblackchemist** » Mon Nov 21, 2011 6:07 am

Done.

Four Wheel Forum

Aluminum polishing intro

Aluminum polishing intro

Aluminum polishing Tutorial

Fins and ports and head polish etc...

polishing aluminum